1. Clean the surface
- Remove all dirt and grits off the surface.
- You can use water and then dry it.
- You may want to use solvent, but check whether it is ok to use on the surface.
2. Rub the vinyl decal with your fingers
- Put the decal on a flat surface
- Rub the decal to make sure the white vinyl sticks to the clear piece
3. Carefully (and Slowly) peel the vinyl off the backing paper
- Peel very very slowly, make sure all white vinyls are stuck to the clear piece.
4. Stick it to the surface
- Carefully place it on the surface. Align using the white vinyl decal, NOT the edge because the edge is NOT parallel to the vinyl.
- And then rub with your fingers to ensure that vinyl sticks to the car surface.
5. Slowly peel the clear piece off
- Don't let the white vinyl come off the car
6. Finished!
- If you end up with any bubbles, poke it with a sharp pin and rub. Let the air out.